![]() I bought one on ebay, but it does not fit. My primary card have a secondary channel, but I'm not using it, as it is either a svga-output or I'd need a dvi to vga splitter. When I look at the properties for the second screen, it is shown as connected to the same card as my primary card, not to the USB video. If I extend the desktop to both screens, windows allows me to drag something to the right of the main screen, so it thinks the second screen is there. If I select "Duplicate the screens", the second monitor only shows a un-movable white mouse pointer in the center of a black screen. However, I can not get anything usefull on the second monitor, on the Fresco. ![]() In the "screen resolution" setup, it properly shows my two monitors, identifiable by the model names. With the driver from, it show up a a USB Video class device. With the driver which came on CD, it showed up as an A/V Class Device ![]() I have a Fresco Logic USB3.0 VGA Display "dongle", however I only have USB2-ports, so I must accept I only get 800圆00. Even if your user has administrator rights, you must specify Run as administrator.I have windows 8.1 pro on a Dell Optiplex 740 NOTE: if in any of these steps, you get Access Denied, this is because you did not execute the command prompt as an administrator but you ran it as a normal user.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |